|
|
What is
Microdermabrasion?
Microdermabrasion (often referred to as Microderm) is a
cosmetic procedure popular in day spas, doctors' practices, and medical spas, in which the
stratum corneum (dead outermost surface of the skin) is
partially or completely removed by light abrasion. Different
methods include mechanical abrasion from jets of zinc oxide or
aluminum oxide crystals, fine organic particles, or a roughened
surface. Particles and removed material are vacuumed off through
the wand/hand piece through which the abrasive particles come.
Microdermabrasion is used to remove sun-damaged skin and to
remove or lessen scars and dark spots on the skin. The procedure
is not very painful and requires no anesthetic.
Microdermabrasion can be used medically for scar removal when
the scar is raised above the surrounding skin, but is less
effective with sunken scars. There is very little, if any,
evidence that microdermabrasion stimulates collagen formation.
Microdermabrasion can also be used for treatment of acne, but
must be repeated periodically to be effective. Microdermabrasion
should not be used on patients who have taken the medication
Accutane (Isotretinion) in the previous six months.
Microdermabrasion
is a relative newcomer to the
United States. This technique
was first used in Europe and adopted by
United States in the late
1990s. Today, Microdermabrasion is used effectively to treat
fine wrinkles, stretch marks, and scars left from moderate to
severe acne. The term dermabrasion refers to the more
severe medical procedure carried out under general or twilight
anesthesia.
Microdermabrasion Procedures:
Procedure No.1: Peeling
Instead of using harsh chemicals such as zinc and metal oxides,
microdermabrasion peels capitalize on the power of
debris-leeching micro-crystals. They shouldn’t be painful, but
rather very comforting like a deep tissue massage!
Microdermabrasion peeling can be done easily and quickly in an
outpatient clinic, at a spa or even at home as mentioned
earlier.
The device is
a hand-held machine which deeply exfoliates and cleans the
skin’s surface. Regimens normally consist of 4-6 peels within
1-2 week intervals and then followed by a conditioning peel
every 6 weeks or thereabouts where necessary.
In simple
terms, a sand jet or sandblaster shoots fine sand particles onto
the surface of the skin in an oscillatory motion. The friction
that this motion creates abrades the surface of dead skin cells
on the upper-most layer of the skin.
Procedure No.2: Corundum
and Aluminum Crystal Machines
The most commonly type of crystal used in microdermabrasion
machines are corundum or aluminum oxide. The reason for this is
that they are firstly, great materials for cutting and abrading
because of their coarse, un-even surfaces. Second, their
hardness is second only to diamonds, but cheaper. Third, they
don’t cause allergic skin reactions, such as eczema, psoriasis,
or itching they don’t interact chemically and are not absorbed
by the skin. Finally, the crystals have a bactericidal property
which is a plus for treating acne as acne is most commonly due
to bacterial infection.
Procedure No.3: Other
Crystal Machines
Other crystals instead of corundum can be used for
microdermabrasion, and these include, sodium chloride crystals,
sodium bicarbonate crystals, and magnesium oxide crystals. The
benefit of using these methods is that it is cheaper overall,
however be weary of the efficacy compared to standard crystal
techniques.
Does
Microdermabrasion Hurt?
When
selecting any
ClearFX
microdermabrasion machine
you can be assured that your patients will never feel any pain.
You will be able to get all the areas of the face including the
eyelids and all around the eyes, the crystals will flow only
where they are applied. The patient normally works up a level as
they go to increase the penetration to the skin and their skin
may feel a little hot and appear a bit red for the first
treatment but will be perfectly fine that same day. A normal
microdermabrasion treatment varies depending on your patients'
skin and the sensation of the procedure has been attributed to
the sensation of a slight windburn.
Many have
hailed microdermabrasion as the miracle cure for Acne. Yes it
can remove many of the scars left by Acne. It can clear out
clogged pores and remove all the excess sebum (oil). It will
invigorate the skin making it far healthier looking. However it
is very important that microdermabrasion is never used on skin
that has an active outbreak of acne. A well trained professional
may be able to work around your acne but you should NEVER use a
home microdermabrasion kit while you have an outbreak. Sadly
micro-dermabrasion can not remove deep scars but it can reduce
them greatly so that they are no longer as visible as they once
were. Even better is the fact that microdermabrasion has been
proven to stop acne from coming back! Yes, it will help bring it
under total control but only if a maintenance course is adhered
to. |
|